
74 Z-Surveyor & Z-FX Operation Manual
Base System Setup
You must have RTK Base option [K] installed on the receiver and if RTCM 18/19 is
to be used, the RTCM Base option [B] also.
1. Place the receiver in RTK Base mode
a. From the main menu press
↑
<2 seconds
until
SURVCONF is selected.
b. With
SURVCONF selected, press
↓
>2 seconds to enter the submenu.
c. Within the
SURVCONF submenu, press
↑
< 2 seconds repeatedly until MODE
is selected.
d. If
RTK BASE is not displayed, press
↓
<2 seconds to place the receiver in
edit mode.
e. Press
↑
< 2 seconds repeatedly until
RTK BASE is selected.
f. Press
↑
+
↓
<2 seconds to accept the parameter setting (pressing
↑
+
↓
>2
seconds cancels the parameter setting).
2. Select output port and base data type to send.
a. Press
↑
< 2 seconds repeatedly until
PORT/TYPE is selected.
b. Press
↓
>2 seconds to place the receiver in the
PORT/TYPE submenu.
c. Press
↑
<2 seconds to select the port through which the base data will be
sent.
d. Press
↓
<2 seconds to enter the edit mode.
e. Press
↓
<2 seconds to select
OFF/DBEN/RTCM. (“RTK BASE” on page
49).
f. Press
↑
+
↓
<2 seconds to accept the parameter setting (pressing
↑
+
↓
>2
seconds cancels the parameter setting).
3. Enter a base position
a. From the main menu press
↑
<2 seconds until
SURVEY:RTK BASE is
selected.
b. With
SURVEY:RTK BASE selected, press
↓
>2 seconds to enter the
submenu.
c. Within
SURVEY:RTK BASE press
↑
<2 seconds until BASE POS is
displayed.
d. Press
↓
>2 seconds to enter
BASE POS submenu.
e. Press
↓
<2 seconds to edit the latitude.
f. Press ↑ or ↓ <2 seconds to change 1st digit of latitude.
g. Press ↑+↓ <2 seconds to accept new digit (Press ↑+↓ >2 seconds to
cancel parameter setting).
h. Repeat steps f. and g. for all the digits of the latitude.
Kommentare zu diesen Handbüchern