Ashtech ProMark 200 Spezifikationen PDF herunterladen (Seite 10)

English

• On receiver side, tap OK after successful installation of

Ashtech TTSBase.CAB.

• Go back to your computer and click OK to close the

message window and proceed. The installer on the

computer then runs the same sequence as the previous

one, this time to copy Ashtech Required Data.CAB to the

receiver.

• Again, a message on the computer tells you to check the

receiver screen.

• As previously, the receiver asks you to choose the location

where to install Ashtech Required Data.CAB. Choose the

same location as before for the Ashtech TTSBase.CAB file

(i.e. “Device”), and then tap Install.

• On receiver side, tap OK after successful installation of

Ashtech Required Data.CAB.

• Go back to your computer and click OK to close the

message window and proceed.

• A third round, similar to the first two ones, is then run to

install ProMark Field: Choose “Device” on the receiver

where to install ProMark Field and tap Install.

Wait until the installation is complete. The receiver then

re-boots automatically. Once re-booted, the ProMark Field

option can be seen on the Today screen.

• On computer side, click OK to close the message window,

then Close to quit the installation program.

Entering the

Activation Code

You will not be able to use ProMark Field until you enter an

activation code. This code can be seen on the adhesive label

placed on the ProMark Field CD box. This code was generated

from your receiver serial number. To enter the activation code:

• Tap on the “ProMark Field” line on the Today screen. A

message is displayed showing the serial number of your

receiver and a blank activation code field.

• Type your activation code in the blank field.

•Tap OK to validate the code entry. If the “serial number/

activation code” pair matches, then ProMark Field is

normally started right after tapping OK.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

Keine Kommentare

Ashtech ProMark 200 Spezifikationen Seite 10