Ashtech ProMark 200 Spezifikationen PDF herunterladen (Seite 27)

English

• When you estimate that enough data have been recorded,

taking into account the value of the Range Achieved, tap

Stop.

NOTE: You may tap on the Log button again and resume

data logging for the same Site ID name (or for a different

name). This will create a new raw data file (G file), which

by default will be the only one to be seen as a static

observation when imported in GNSS Solutions. In the job

file (csv file), this will result in two points collected.

• Select Menu, Exit to close the job and quit ProMark Field.

Rover Collecting

Raw Data in Stop &

Go Kinematic

In Stop & Go kinematic, the rover antenna is placed

successively over several points and each time, a static

occupation takes place for a preset time. Raw data are

collected continuously in the background.

• Set up the rover as explained in Typical Setups on

page 17.

• Turn on the receiver, run ProMark Field and create a job

as explained in Creating a New Job on page 10.

•On the Options menu, select “Stop & Go Kinematic” and

“Post-processing” on the Survey tab, then tap OK.

• Think about which initialization method you will be using

at the beginning of the project and take the corresponding

steps:

– From Known Point: Go to the known point and place

the rover antenna exactly over this point.

– From Bar: Go to the base (fitted with the initializer bar)

and place the rover antenna at the free end of the

initializer bar.

•Tap Menu and select Configuration...

• Select “Rover” from the Configuration drop-down list.

•Tap Settings.

•On the GNSS tab, make sure the “Internal” GNSS receiver

is selected. Ignore the Port field.

• Tap on the Antenna tab,

• Select “Vertical” and enter the antenna height, which in

this case corresponds to the pole or bipod length.

If you are using a fixed-height pole, just enter this height.

if you are using a height-adjustable pole or bipod, read the

graduation on this device, and then enter the read value

in the Antenna Height field.

• Select the antenna type used.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Ashtech ProMark 200 Spezifikationen Seite 27

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Navigatoren Ashtech ProMark 200